Final Assembly; Attendance - KERN and SOHN TYPS-03A-B Notice D'installation

3.3 Final assembly

Place the outer frame over the inner frame. Using the adjustment feet to level both
frames until they are in level position. Adjust the rubber blocks in a way that the
granite slab protrudes 2-5 mm over the working surface and rests firmly (see fig. 10).

4 Attendance

• Do not disassemble the weighing table without looking at the assembling
instructions.
• Do not shift the table by force or abruptly. We recommend you lift the table
and then cautiously put it down again.
• To clean off stains, wipe the table with a soft cloth soaked in detergent. Do
not use organic solutions for wiping off stains.
• Place the weighing table in a dry and clean environment. Do not install out
of doors. Do not use in the vicinity of fire or in environments with high
temperatures. Avoid exposure to direct sunlight.
10
Figure 10
Final assembly drawing
1x Granite
1x Table top
4x Marble adjusting screws
1x Outer frame
1x Inner frame
8x feet
YPS-03-IA-e-1910