KERN and SOHN TYPS-03A-B Notice D'installation page 15

4. Remove the inner side rail (lefthand) from the upper packing layer and the
inner side rail (righthand) from the middle packing layer and fix them with the
M8x40 screws using the hexagon wrench. (See fig. 3)
5. Remove the lower granite supporting rail from the upper packing layer and fix
it by the two M8x40 screws; for this purpose open the two side frames slightly
in order to insert the rails into the frames. After that tighten the 6 screws as
shown in fig. 3.
After that the two sides should be aligned in a parallel and straight manner.
6. Fix the four rubber blocks as shown in fig. 4.
7. Put upon the granite block and center it as exactly as possible. Fig. 5 and 6
show the completely assembled inner table.
1 x Inner side rails (left)
Take care that the screws are fitted in such a way that they are sunk in
the recesses.
(Do not allow screws to protrude - risk of injuries!)
YPS-03-IA-e-1910
1 x Granite
support rails
1 x Supporting rail (lower)
Figure 3
Inner frame assembly
1 x Inner side rails (right)
6x M8x40 socket screws
5