IMG STAGELINE PAK-110MK2 Mode D'emploi page 9

CAUTION! To prevent acoustic feedback, do not
hold the microphone towards the speaker or too
close to it. Feedback may also occur when the vol-
ume is too high. In this case, reduce the micro-
phone volume with the corresponding control
LEVEL (7) or (8).
6) Adjust the sound as desired with the two controls
TREBLE (11) and BASS (12).
6 Specifications
Model
Amplifier power
RMS power
Peak power
Frequency range
Max. rated SPL
Bass speaker
Tweeter
Input sensitivity
MIC IN, XLR jack and 6.3 mm jack
LINE IN, XLR jack
LINE IN, phono jacks
Output LINE OUT, XLR jack
and 6.3 mm jack
Ambient temperature
Power supply
Power consumption max.
Dimensions (W × H × D)
Weight
Pin configuration of XLR jacks:
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
7) With the control MASTER LEVEL (10), adjust the
desired overall volume. Only turn up the control to
such an extent that the sound reproduced will not
be distorted. If the overload LED CLIP (13) lights
up, turn back the control accordingly. Then readjust
the sound, if required.
8) After use, switch off the speaker system with the
POWER switch.
PAK-110MK2
110 W
200 W
59 – 20 000 Hz
116 dB
25 cm (10")
dynamic horn tweeter, 2.54 cm (1")
6.5 mV
150 mV
620 mV
230 V~/50 Hz
300 VA
360 × 500 × 260 mm
12.9 kg
1 = ground
2 = signal +
3 = signal -
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
PAK-112MK2 PAK-115MK2
150 W 175 W
270 W 300 W
49 – 20 000 Hz 45 – 20 000 Hz
118 dB 119 dB
30 cm (12") 38 cm (15")
10 mV
240 mV
950 mV
200 mV
0 – 40 °C
230 V~/50 Hz 230 V~/50 Hz
340 VA 370 VA
430 × 580 × 310 mm 447 × 685 × 355 mm
20 kg 22.8 kg
T = signal +
R = signal -
S = ground
Subject to technical modification.
GB
9