Disposal; Troubleshooting - Saeco ROYAL DIGITAL SUP 015 Instructions D'emploi Et D'entretien

42
Maintenance
Periodically check the machine and clean it in
accordance to the instructions.

Disposal

Machines which are no longer operational
should immediately be made non serviceable,
by cutting the power cord. Machines should be
delivered to a public disposal centre.

Troubleshooting

In case of failure, fault or suspected
damage following a fall, unplug the
machine immediately.
To fix problems, follow the instruc-
tions in the table below. Otherwise
contact authorised personnel.
43
DISPOSAL
Trouble
No message on the
display
The automatic coffee
brewing does not start
The automatic coffee
brewing does not start
Water is dispensed
instead of coffee
Steam and/or hot water
are not dispensed
Coffee flows too quickly
Coffee is flows too slowly
Coffee is not hot enough
Coffee is not creamy
The coffee brewing is re-
duced, the machine takes
longer to heat and the water
capacity is not correct
The central unit cannot be
removed
Only skilled personnel are authorised to service and repair the machine. The user might incur serious injuries should repairs
not be properly carried out. The manufacturer declines any liability whatsoever, should repairs fail to be carried out
according to the instructions contained in this manual. Furthermore, in these cases warranty rights cannot be honored.
Possible cause/causes Resolution
The machine is not getting power Turn the main switch on, check plug
and fuse
The service door is open Close the service door
Insert and lock the central unit
BREW UNIT MISS
Clean the central unit (see page 38)
BREWUNIT BLOCK.
The steam key is being pressed Disactivate the steam function and
drain the machine (see page 32)
Fill with water or coffee beans and
COF.BEANS EMPTY
WATERTANK EMPTY
READY FOR USE restart the cycle
Drain thoroughly the machine again
OVERTEMPERATURE
Fit the coffee grounds container
DREGDRAW. MISS.
properly
Clean the grinder
GRINDER BLOCKED
The pre-ground coffee selection key Fill with pre-ground coffee
has been pressed while there is no
coffee in the container
The steam/hot water spout hole is Clear it with the aid of a thin needle
clogged
Grinding too coarse Adjust the grinder to a finer grinding,
ex. from 6 to 3
Grinding too fine Adjust the grinder to a coarser grind-
ing. ex. from 6 to 7
The central unit filter is jammed Clean the filter
The cup has not been preheated Place the cup on the heating plate
The coffee blend is not suitable, Try another coffee blend
coffee has not been recently
ground, the pre-ground coffee has
been ground too thin or too coarse
Limescale in the machine Carry out the machine descaling, as
described at page 40
The central unit is out of position Switch on the machine. Close the
service door and fit the coffee grounds
container. The machine returns auto-
matically in its starting position.
TROUBLESHOOTING