Control Panel Description; Unpacking/Installation; Power Supply Connection; Starting And Use - Saeco ROYAL DIGITAL SUP 015 Instructions D'emploi Et D'entretien

30
1
Coffee grounds container
2
Drip tray
3 Cup holder surface
4
Main switch
5
Power cord
6 Coffee dispensing unit
7
Steam/hot water dispensing tube with heat
protector
8
Control panel
9
Steam/hot water selection knob
10
Heating plate for cups
11
Water tank
12 Water tank cover

Control panel description

Digitaldisplay-Anzeige
Digital display
Standby-Schalter
Standby switch
Ein/Aus Energiesparmodus
Standby mode on/off
Starttaste 1 bzw. 2 Tasse/n Kaffee lang
Selection key for 1 or 2 cups of tall coffee or key
oder Pfeiltaste « » im Programmiermodus
<< >> in the programming mode
Selection key for 1 or 2 cups of regular coffee Starttaste 1 bzw. 2 Tasse/n Kaffee
or key << oder Pfeiltaste « >> in the programming mode » im Programmiermodus
Starttaste 1 bzw. 2 Tasse/n Kaffee Espresso
Selection key for 1 or 2 cups of espresso coffee or key <<ESC>> in the programming
oder « »-Taste im Programmiermodus
mode
Taste zur Anwahl Kaffeepulver oder « »-Taste im Programmiermodus
Pre-ground coffee selection button or key <<ENT>> in the programming mode
Steam selection button Taste zum Ein-/Ausschalten des Dampfes
CONTROLS AND MACHINE PARTS
13
Water level
14
Pre-ground coffee container with cover
15 Coffee bean container cover
16
Coffee bean container
17
Grind adjustment lever
18 Coffee dosage adjustment lever
19
Service door
20 Filling funnel
21
Handle for assembling and disassembling
of central unit
22
Central unit
23
Coffee rest drawer
24 Swivel
"WARMING UP"
Aufheizen...
31

Unpacking/Installation

Standard packing is strong enough to protect
the machine during mail shipping. Keep this
package to return the machine to the manufac-
turer should it be necessary.
Before installing the machine, keep to the
following safety indications:
Position the machine in a safe place.
Do not allow children to play with
the machine.
Make sure the machine is not placed
nearby hot surfaces or open flames.
Always use the machine with the swivel (24).
Thus, when installing the machine, make sure to
rest it directly on this support by inserting it into
the slot on the lower side of the machine.
Now the machine is ready to be connected.

Power supply connection

Warning: electric current may cause
death!
The coffee machine must be connected to an
adequate socket. Voltage must suit to the volt-
age specified on the appliance rating plate.
Never use defective power cords.
Defective power cords and plugs
must be replaced by authorised personnel.
Should an extension cord be used,
check its perfect condition. The ex-
tension cord must have a minimum section of 1
mm 2 and must be supplied with a three-pole
plug/socket.
UNPACKING/INSTALLATION

Starting and use

Danger!
Electric voltage may cause death!
Parts under current shall never be in
contact with water: danger of short-
circuit! Overheated steam and hot
water may cause burns. Do not direct
steam or water jet towards the body;
furthermore, great attention must be
given when touching either the dis-
pensing tube or the heating plate:
danger of burns!
For your own safety as well as for
other people's safety, keep to the
safety precautions described (see
page 29).
Never use the machine without water
or coffee beans.
Remove measuring spoon, brush and the cen-
tral unit key from the coffee grounds container
(1) and keep them within reach.
Unwind the power cord (5) from the rear side of
the machine.
25 The bean coffee container (16) is attached
with two screws. Remove the cover (15) and fill
it with coffee beans (approx. 300 g), then
replace the cover.
Adjust grinding by means of the grind adjust-
ment lever (17), positioning it on point <<5>>
of the scale.
Never fill the coffee bean container
with other products. They might dam-
age the machine!
Before filling the container with cof-
fee beans, make sure the pre-ground
coffee container is closed to prevent coffee
beans from falling into it. They might damage
the machine!.