Disposal Of Packaging Materials; Electrical Connection; Setting Water Hardness - Saeco OFFICE One SUP028R Mode D'emploi

Adequate clearance must be provided to allow users to freely ac-
cess the machine and plug and leave the area immediately in case
of need.
The illustration shows the minimum spaces for accessing:
• the control panel on the front part
• the components that may require servicing in case of machine malfunction-
ing.
100
200
After positioning the packing container near the installation site, proceed as
follows:
• make sure that the original packing container is closed and intact and has
not been tampered with during transport;
• open the packaging;
• check the condition and model of the packed machine;
• check the contents of the bag of accessories enclosed with the machine
(see "10.3 List of supplied accessories");
• remove the machine from its original packaging;
• free it from any remaining packaging material;
• then lift the machine and position it in the site prepared beforehand.
10.5

Disposal of packaging materials

After the packaging has been opened, the packaging materials should be sepa-
rated according to type and disposed of in accordance with the regulations in
force in the user's country.
We recommend keeping the packaging for future conveyance or
transport.
10.6

Electrical connection

This operation should be performed only by specialised technical
personnel or by the service provider.
The machine is designed to operate with single-phase voltage: the voltage rat-
ing is shown on the identifi cation plate (1.4 Machine identifi cation).
Before plugging in the machine, make sure that the ON/OFF switch is posi-
tioned on "0".
The Service provider makes and is responsible for the electrical connection of
the machine.
The machine must be connected to the power supply via the plug installed on
the power cord, bearing in mind:
• The laws and technical standards in force at the time of installation;
• The technical data shown on the plate on the side of the machine.
Installation of the machine - Service Provider Manual
400
200
200
sizes in millimeter
Warning: the electrical socket which the machine is connected to
must be situated within convenient reach of users, so that they
can easily disconnect the machine from the mains power supply when
necessary.
It is forbidden:
• to use extension cords of any type.
• to replace the original plug.
• to use adapters.
10.7

Setting water hardness

This function allows you to set the degree of water hardness so that the ma-
chine will signal the need for a descaling treatment at the right time.
Warning. To make this setting, carefully read the directions pro-
vided in section 11.
The hardness of tap water may vary depending on the region.
For this reason, the appliance can be set according to the water hardness in the
place where it is to be used, expressed on a scale of 0 to 4.
The appliance is factory set to a standard value (hardness 1).
The setting should be adjusted according to the amount of lime present, or to
the level of hardness of the water supply, which can be measured using the
strip provided with the machine.
Briefl y dip (1 second) the provided strip in water and shake it gently.
After one minute the test results can be read on the strip.
HARDNESS 4
Sehr weiches Wasser
HARDNESS 3
Weiches Wasser
Mittleres Wasser
HARDNESS 2
Hartes Wasser
HARDNESS 1
HARDNESS 4 (hard)
HARDNESS 3 (medium)
HARDNESS 2 (soft)
HARDNESS 1 (very soft)
HARDNESS 0 (descale control disabled)
After completing the test, set the corresponding value on the machine.
• 39 •