Replacing The Blade - Elem Garden Technic TH3.6V-2IN1 Traduction Des Instructions D'origine

REPLACING THE BLADE

Wear protective gloves to
replace blades.
Dismantling
▪ Press the unlocking button and push the cover
towards the On / Off switch.
▪ Remove the casing cover.
▪ Take out the blade.
Mounting
▪ Adjust as shown in the figure the notches in the
blade to the rods in the unit and mount the blade.
▪ When mounting the hood, make sure that all 4
latching devices are in the housing before the
hood is pushed into the correct position.
▪ Push the cover towards the blade to make it
snap.
INSTRUCTIONS
Hedge trimmers
Cut the hedges
Before beginning the operation,
check that foreign objects are
not hidden in the hedge, such as
It is possible to cut branches up to 6 mm thick. In
order to approach the knife branches, move the
machine evenly along the cutting line.
The knife bar with blades on both sides allows
cutting in both directions or back and forth
movements. After use, replace the transport
protection.
Recommended seasons:
It is recommended to trim leafy hedges in June
and October.
Coniferous hedgerows in April and August.
cut conifers and other hedges that grow fast
from May every 6 weeks.
fences.
31
Grass shears
Cut the edges
Guide the device along the edge of the lawn.
Avoid the blade coming into contact with the
pavers of the floors, stones or garden walls, since
this considerably reduces the longevity of the
blade.
CLEANING
Note: To ensure long and reliable use of the
appliance, perform the following maintenance
work at regular intervals.
▪ Check the device for visible defects such as a
loose, loose or damaged blade, loose
connections or worn or damaged parts.
▪ Check that covers and guards are undamaged
and properly installed. The necessary
maintenance or repair work must be carried out
before using the appliance.
▪ If, despite all the care taken in the manufacture
and control of the appliance, it should have a
defect, the repair should only be entrusted to our
technical department.
Blade maintenance
After each use, regularly clean the blades and
grease them with maintenance spray. For longer
cutting jobs, it is recommended to lubricate the
blades regularly with maintenance spray.
Check the condition of the cutting edges of the
blade.
Make sure the blade is covered by the attached
protection when not in use.
Cleaning / storage
Clean the outer parts of the appliance carefully
with a soft brush or a cloth. Do not use water or
solvents or abrasive detergents. Remove any
residue adhering to the appliance, especially on
the ventilation openings. Store the unit in a dry,
secure place out of the reach of children. Do not
put other objects on the machine