Operation - Royal Sovereign RWD-1600B Guide D'utilisation

OPERATION

After the water bottle has been connected to the water dispenser, the unit is ready for use. Turn the power switch on the back of the unit to
ON. The water dispenser will start running. First the unit will pump the water from the water bottle into the cooling and heating tanks, and
then the unit's compressor and heater will start to operate.
When operating the water dispenser for the first time, you will need at least 30 minutes for the hot and cold
water to reach the desired temperatures.
The water dispenser has 3 indicator lights on the front panel.
• When the left indicator light is on, the unit is in the process of cooling water inside the cooling tank.
• When the right indicator light is on, the water dispenser is heating water inside the heated water tank.
• When the indicator light on the front panel is on, there is no water left in the water bottle. The water bottle
needs lo be replaced. Replace the water bottle, and close the door lo reset the unit. The water dispenser will work
again and Ihe indicator light will turn off.
Using the Water dispenser
• To dispense HOT water, slide the Hot Water Handle to the left side and then press the button down.
• To dispense COLD water, press the cold water button down.
• To dispense Room Temperature water, press ihe room temperature button down.
7
RW-1600B