Preparing The Water Dispenser For Use - Royal Sovereign RWD-1600B Guide D'utilisation

Masquer les pouces Voir aussi pour RWD-1600B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PREPARING THE WATER DISPENSER FOR USE

This model is different from a traditional water dispenser. The water bottle does not need to
bo placed upside down on the top of tlie unit. The water bottle is placed in the cabinet of the
unit, and then a pump draws the water up to the dispenser.
For ideal usage, it is recommended that 1 or 2 bottles of water runs through the water
dispenser before use
IMPORTANT NOTE: LET THE WATER DISPENSER STAND UPRIGHT FOR ABOUT 24 HOURS.
THIS WILL HELP REDUCE THE POSSIBLE MALFUNCTION IN THE COOLING SYSTEM FROM
POSSIBLE MISHANDLING DURING DELIVERY OF THE UNIT
BEFORE PLUGGING IN THE WATER DISPENSER
1. Make sure the water dispenser is not plugged into an electrical outlet.
2. Open the door of the lower cabinet.
3. Place full water bottle on floor. Remove the plastic cover over the mouth of the water bottle.
4. Place the stainless tube inside the bottle and place the water bottle cap firmly over the mouth
of the water bottle.
5. Attach the hose to the top of the cap using the quick connect system shown below.
6. Slide the bottle inside the cabinet and close the lower cabinet door.
7. Plug the water dispenser into a grounded power outlet and turn on the power switch located on the back.
8. The unit is now ready, however, it is recommended that you wait a minimum of 30 minutes before usage.
9. It is recommended that if Hot Water option is not used, the Hot water button (red button) be
turned OFF. This will help conserve energy.
5
RW-1600B

Publicité

Chapitres

Table des Matières
loading

Table des Matières