Electrical Connection; Chimney Assembly; Upper Chimney - Faber EG6 BK A45 Manuel D'instructions

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch
having a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) be-
ing sure that the connector of the feeding cable is correctly
inserted in the socket placed on the side of the fan.

Chimney Assembly

• Fasten the Chimney fixing element 19 to the Body using 4
screws 12c.

Upper chimney

• Open the two side pieces out slightly, hook them up behind
the brackets 7.2.1 and bring them back together again until
they are in contact.
• Fix to the Brackets at the sides, using 4 screws 12c (2.9 x
9.5) provided.
• If there are any, make sure that the Connector extensions
outlet is in correspondence with the Chimney openings.
Lower chimney
• Open the two side pieces of the Chimney out slightly, hook
them between the upper chimney and the wall, and then
close them together again until they are in contact.
• Fix the part at the sides to the Chimney fixing element 19,
using 2 screws 12c (2.9 x 9.5) provided.
EN
8 8