Adjustment Of The Distance Between Centers With Installed Bar - Ultraflex A96 Manuel D'installation Et D'entretien

ULTRAFLEX

2.4 Adjustment of the distance between centers with installed bar

If during the use of the boat it is necessary to vary the distance between centers of the engines (i.e. the angle of
divergence or convergence), proceed as follows.
WARNING
Before carrying out the following operations, it is mandatory to turn off the engines and operate in safe conditions.
1 By means of a 22 mm wrench loosen ring nut
(1) holding it still with a second wrench on the end
element (2).
2 Proceed as shown on paragraph 2.3
page 12
of 47
- TIE BAR A96
Installation and Maintenance Manual
2
1