Switching On The Pedelec; Switching Off The Pedelec - Raleigh PEDELEC IMPULSE EVO Notice Originale

6.3.1

Switching on the pedelec

The system can only be activated if a sufficiently charged
battery has been inserted.
Do not switch on the pedelec when you are riding.
Otherwise the motor can stop and you will not be provided
with the full assist level.
1. Press the
button on the easy-reach control for one second. The
display light turns on. On the Impulse Evo (Smart) pedelec, the display
light goes out after about 30 seconds. The cycle light also switches on.
A welcome message appears in the information field of the display. If
you have an Impulse Evo / Impulse Evo Next system with back pedal,
"Please pedal" is shown. You can configure other settings from the
start menu.
ECO
140 km 00:02
0
.0
km/h
Trip time Trip
00.00.00 0.00 km
Impulse Evo (Smart) display:
Start menu
POWER
140 km 00:02
0
.0
km/h
Trip time Trip
00.00.00 0.00 km
11:18
OFF 140km
0.0
km/h
Trip 0.0 km
Impulse Evo Smart Compact display:
Start menu
If the system does not switch on
despite pressing the
the battery button for one second. The
pedelec switches on. If it still does not
switch on, check the battery
Display panel Page
6.3.2 Switching off the pedelec
DANGER
Only ride the pedelec when you can safely reach the brakes
Braking Page EN-22. Your pedelec does not have an Emergency stop
button. You must activate the brakes to stop the cycle quickly in a
dangerous situation. The maximum brake force is greater than the
propulsion force possible. This means stopping is guaranteed at all
times by pressing the brakes. Note that the drive system does not
disable automatically after braking. Switch the drive system to idle
after braking.
On the easy-reach control
1. Press the
button on the easy-reach control for one second.
The Impulse Evo system switches off.
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
button, press
 9.3.1
EN-84.
Battery button
 3.7
EN-49