Quick-Start Guide; Charging The Battery; Inserting And Locking The Battery - Raleigh PEDELEC IMPULSE EVO Notice Originale

Type Characteristics
Lights Check that the light system is adjusted and in working order.
Check that reflectors are affixed in accordance with applicable
national traffic regulations.
Threaded joints Check that all threaded joints are tightened as specified.
Luggage Check it is attached securely.
5.

Quick-start guide

5.1

Charging the battery

If you only want to go for a quick test run, you do not need
to charge the battery. You should charge it before your first
longer cycle ride however,
Page EN-93, because the battery is only partially charged
(production regulations dictate that batteries are supplied
partially charged by approx. 50 %).
IMPORTANT
Perform a 'learning cycle': You should completely run down a new,
fully charged battery once until the drive assistance stops and
without recharging it in between. In that way, the battery 'learns' its
capacity, and the actual capacity will agree with the level indicated on
the battery status display. As soon as the battery enters Sleep mode,
press the battery button for one second. Then the learn cycle can be
continued. Please perform a learn cycle every six months or 5,000
kilometres. If you do not repeat this from time to time, the actual
capacity of the battery will increasingly diverge from the value on the
battery status display.
 10.3.1 Charging a battery
5.2

Inserting and locking the battery

IMPORTANT
Grasp the battery firmly, so that it does not fall out of your hand. It
can be damaged if you drop it.
Seat tube battery: Impulse Evo pedelec
1. Hold the battery, with the discharger
connector pointing downwards, at an
angle of 80˚, slightly tilted to the left
in front of the docking station.
2. Place the battery catches into the
dents provided.
3. Push the battery forwards and upwards
into the docking station until the
locking mechanism engages.
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
For 1. Hold in front of the docking station
Battery nib
and recesses
For 2. Battery nibs into recesses
For 3. Push battery into docking station
EN-37