IKEA OVERSKADLIG Manuel D'instruction page 10

ENGLISH
Levelling feet
If the appliance tilts in some way, adjust the
height of the left/right foot of the appliance
to level the appliance. Refer to the separate
Assembly Instructions for detailed installation.
1. Disconnect the mains plug of the appliance
from the power socket.
2. Turn the foot clockwise to raise the
appliance; turn the foot counter clockwise to
lower the appliance.
Levelling doors
If the doors of the appliance are not aligned,
adjust the height of the doors to be in a
horizontal level. Refer to the separate Assembly
Instructions for detailed installation.
1. Disconnect the mains plug of the appliance
from the power socket.
2. Raise the low door to align with the higher
door.
3. On the bottom of the low door, use a a pair
of pliers (not supplied) to insert a supplied
fastener-ring into the gap between the
hinge and the hinge-grommet. Insert more
supplied fastener-rings for height increase
(if needed) until the two doors are aligned.
35.63"
60.31"
Unlevel
Installing water filter cartridge
Install the water filter cartridge before the water
filter equipped in the appliance can be used.
Refer to the separate Assembly Instructions for
installation.
Connecting to water supply line
Connect the appliance to a drinking water line
before the water and ice dispenser equipped in
the appliance can be used. Refer to the separate
Assembly Instructions for installation.
Installing distance holder
Warning! Serious or fatal crushing injuries
can occur from appliance tip-over. ALWAYS
secure this appliance to the wall using tip-
over restraints.
Using the supplied distance holder to fix
the appliance to the wall for the following
advantages. You must follow the separate
Assembly Instructions to correctly install this
distance holder/anti-tip bracket.
• Allow enough space for air circulation
between the appliance and the walls.
• Secure the appliance to the wall for tip-over
prevention.
10
Hinge-
grommet
Hinge