Timer Settings - Sonnenkonig SAHARA Notice D'utilisation

6. Timer settings:

• By pressing the button C the timer indicator will be on, the LED light flickers. Press the button
D/E to set the timer.
• Timer range 1-12 hours.
• If the value shows 0 in timer setting, the time indicator will be off, LED display will show the
GB
current room temperature.
7. Adjusting heating power:
• By pressing the button B switch from high heating power to low or ECO mode.
: Low heating.
: High heating power: PTCL and PTCH are turned on. PTCH delay work after 20 seconds.
: ECO mode: Default temperature 22°C.
• Room temperature < 18°C, heater works with high heating power.
• Room temperature > 18°C, Heater works with low heating power.
• Room temperature > 22°C, Heater stops, indicator shows the room temperature.
8. Swing:
• By pressing the button F device oscillate, the icon
9. Continuous electric memory function:
• Under standby mode, press the button A and the unit will keep working as the same status
as last time setting, except the timing function.
10. Reduced brightness:
• After 1 minute of normal operation the brightness of the display should be reduced to 1/3 of
the normal brightness, solving the problem of LED lamp dazzling in night.
will be on, press again, to turn it off.
56