HUUM HIVE Mode D'emploi page 6

NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
as the power cable. The joint box must be waterproof and it must be
located up to 50 cm from the floor.
• Open the cover of the heater's electrical box.
• Attach the power cable on the terminal block according to the
circuit diagram.
• Close the cover.
• Fix the cable on the output with a cable strap.
L1 L2 L3 N
400V 3N
Fitting the stones
• The stones must be washed clean before laying.
• Make sure that the heating elements are not bent during the
process.
• There must be sufficient air circulation around the heater
elements.
• Stack the stones sparsely between the heating elements. If the
stones have been stacked too close to each other, the heating
elements may overheat (= shorter useful life) and slow the
heating of the sauna.
• Stones with a diameter of 5-10 cm are suitable for the heater.
• The stones on the external surface of the heater must be
stacked close to one another. The heating elements must not be
visible.
• Using ceramic stones in the HIVE heater is allowed at the user's
responsibility.
6