Maintenance Cleaning; Daily Cleaning; What Should I Do If - Atag HI511M Mode D'emploi

maintenance
cleaning

daily cleaning

Although food that has boiled over cannot burn on, it is still
recommended that you clean the hob immediately after use.
For daily cleaning, you can best use a mild cleaning agent and
a damp cloth. Dry the hob with kitchen paper or a dry cloth.
stubborn stains
Stubborn stains can also be removed with a mild cleaning
Water marks; lime
stains; traces of agent - for example, washing-up liquid.
Remove water marks and lime stains with vinegar.
metal.
Traces of metals (due to sliding pans) can be difficult to
remove.
Remove traces of metals with a proprietary cleaning agent.
Remains of food that has boiled over are best removed with
a glass scraper. Melted plastic and sugar can also be
removed with a glass scraper.
never use
You should never use scouring agents. These cause
scratches in which lime deposits and dirt can accumulate.
Never use sharp objects such as steel wool and scourers.
tip
Before you start to clean, turn the childproof lock on.
GB 14
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault cause
The appliance does not work No electricity.
and the lights are not on.
The hob does not work. The appliance has been
F9 appears in the display. connected incorrectly.
The hob does not work. Ambient temperature was
F0 appears in the display. too low (5 °C) when the hob
was not connected to the
electricity supply.
The fan switches on The appliance is checking
spontaneously. itself after a power failure.
The cooking zone suddenly Insufficient ventilation.
switches off.
Message F7 appears. Overheating of the
electronics in the hob.
The lights keep blinking after Unsuitable pans.
switching on.
Poor electrical contact.
Appliance does not work. Appliance is locked.
The appliance switches off. Two pans are touching each
other or a pan comes into
contact with the wall.
faults

what should I do if...

solution
Check the electrical
installation (main fuse(s),
connection).
Ask the installer to connect
the appliance again in
accordance with the wiring
diagram.
Wait for about ten minutes
after connecting. The
message disappears.
The fan switches itself off.
Check the ventilation
openings.
Let the appliance cool down.
Press any button and the
message disappears. Start
again on a lower setting.
Use a suitable pan (see pages
21 and 22).
Check whether the cable has
been knocked against by the
drawer. In that case, have the
connection changed by the
installer.
Press the key symbol
for three seconds
continuously.
Make sure that the pans
stand clear.
GB 15