Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
1.0
general information
2.0
2.1
access panel
2.2
burner assembly
2.3
2.4
2.5
2.6
2.7
3.0
3.1
3.2
4.0
4.1
overview
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel
Ltd. reserves the right to change or modify any information within this manual at any time without
notice. Changes, other than editorial are denoted by a vertical line in the margin.
1.0 general information
This rock burner assembly is approved for use in the HD81-1 gas appliance only. It is not approved for use as a
stand alone appliance or in conjunction with any other appliance.
2.0 installation
2.1
access panel
Once either door is removed (refer to the "door removal / installation" section of the HD81-1 manual),
A.
remove the air manifold by removing the two retaining brackets located at the top of the firebox, see Figure
1.
Remove the valve access panel and gasket by removing the 8 screws, see Firgure 2.
B.
Fig. 1
2.2
burner assembly
Attach the burner assembly to the firebox base
A.
with the screws supplied, making sure the pilot
assembly is closest to the valve access opening.
2
W415-0808 / F / 08.30.18
Fig. 2
BURNER
ASSEMBLY
2
2
2
2
3
3
4
4
5
6
6
6
6
7
PILOT
ASSEMBLY
Publicité
Chapitres
Table des Matières
