Installation; Bulkheads; Night Light™ Installation - Napoleon B81NS-1 Manuel D'installation Et D'opération

2.3

bulkheads

note:
Bulkhead covers need to be removed.
Connect the gas flex lines and the pilot line to the gas
A.
bulkheads located under the valve access opening.
Be sure to match up the gas manifold marked with
a dot with the center bulkhead, also marked with a
dot. Care must be taken to ensure the pilot line isn't
damaged and ensuring gas tight connections are
made.
note:
The middle tube is the primary burner and
cannot be turned off. The outside burner can
be turned on and off with the remote. If this
is not the case, switch the flex lines.
Connect the pilot electrode leads to the bulkhead. The
B.
leads can only fit one way. You need to match the 1/4"
flag with the 1/4" bulkhead spade and the 3/16" flag
with the 3/16" spade.
Ensure the 2 venturi tubes are over the orifices before
C.
lighting.
note:
At this stage, we recommend performing
an operational check before finishing

installation.

Check for gas leaks by brushing on a soap and water
D.
solution. Do not use open flame.
After leak test has been performed re-install access panel with gasket (if removed).
E.
2.4 night light™ installation
The HD81-1 comes equipped with two "Night Lights™". The lights have been pre-wired and are controlled from
the remote control.
In the event the lamps or lens need replacing, follow the instructions below:
A. Shut off breaker at main power supply
B. Remove the four screws that secure the lens frame to the firebox sides. This frame retains the glass lens.
C. The lamp can now be accessed.
note:
Do not handle the lamp (bulb) with bare fingers, protect with a clean, dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special "high
temperature" products. When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. "Light Leakage" from the holes in the housing lamp may be
observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
GASKET
LENS
FRAME
BULKHEADS
PILOT
PILOT
ELECTRODE
ELECTRODE
LEADS
VENTURI
TUBE
ORIFICE
JOINT
D'ÉTANCHÉITÉ
LENTILLE
CADRE
NIGHT LIGHTS
W415-0808 / F / 08.30.18
installation
EN
PRIMARY
BURNER
DOTS
PILOT
GAS
BULKHEADS
3