Configure The Instrument; Set The Time Zone And Clock Readout Format - Tektronix 6 Serie Manuel D'installation Et De Sécurité

Configure the instrument

To access the user interface on a Low Profile instrument, connect a monitor to a video port on the rear of the instrument, and
connect a mouse to any USB Host port. You do not need to connect a mouse if your remote monitor is touch-capable. You can
also remotely access the user interface of a network-connected instrument by entering the instrument's IP address in a web
browser.
To remotely set controls or run this task on a Low Profile instrument, see the instrument Programmer Manual (Tektronix part
number 077-1305-xx) for the correct command or commands to use.

Set the time zone and clock readout format

Set the time zone to your region so that saved files are marked with the correct date and time information. You can also set the
time format (12 or 24 hour clock).
To access the user interface on a Low Profile instrument, connect a monitor to a video port on the rear of the instrument, and
connect a mouse to any USB Host port. You do not need to connect a mouse if your remote monitor is touch-capable. You can
also remotely access the user interface of a network-connected instrument by entering the instrument's IP address in a web
browser.
To remotely set a control or run this task on a Low Profile instrument, see the instrument Programmer Manual (Tektronix part
number 077-1305-xx) for the correct command or commands to use.
1. Double-tap the Date/Time badge (bottom-right of screen) to open the configuration menu.
2. To turn off showing the date and time on the screen, tap the Display button to Off.
To turn on date/time display again, double-tap in the blank area where the date/time badge was displayed to open the
configuration menu, and set the Display button to On.
3. Select a time format (12 Hour or 24 Hour).
4. Tap the Time Zone field and select the time zone that applies to your location.
5. Tap anywhere outside of the menu to close it.
LPD64 Installation and Safety Manual 11