Setting Up the Preinstalled Solaris
Operating Environment Software
Your system has the Solaris
software) installed on its hard disk. The exact configuration that has been
preinstalled is as follows:
Disk root partition—4000 Mbytes
Disk swap partition—500 Mbytes
Disk/space partition—the remainder of the disk
As the flowchart below shows, simply power on your system, answer the Solaris
setup prompts, and you are ready to begin using your system. Alternatively, you can
install a newer version of the Solaris software (if any).
Caution – This system requires installation of Solaris 8, software release 10/00 or
later.
START
Power on the system.
Use preinstalled
version of
software?
Answer Solaris software prompts
(using information specific to your site that
your system administrator provides).
READY TO WORK!
en-8
™
See "Powering On the System" on page en-7.
No
Install a
newer
version
(if a
newer
version exists).
Yes
See "Setting Up Your Operating Environment" on page en-9.
operating environment (and additional productivity
Refer to the documentation in your version's Solaris
Media Kit for instructions.
Also see "Getting Started With the Additional Preinstalled
Software" on page en-13.