Installing Optional Hardware En; Preparing For Installation - Sun Microsystems Sun Blade 1000 Guide D'utilisation

Installing Optional Hardware

Preparing for Installation

To prepare for installation of optional hardware, you must power off the system,
remove the access panel, and attach an antistatic wrist strap.
Powering Off the System
Power off the system as follows (see
1. Exit from any applications that are running.
2. Choose one of the two power-off methods, orderly or immediate:
To perform an orderly power-off:
a.Press the power switch and immediately release it.
b. Select Shutdown.
Note – To perform an orderly power-off the system must be booted and the
operating system must be running. If this is not the case the user can, momentarily
press the power switch (The system takes a few seconds to turn off). Now, press and
hold the power switch for four seconds.
To perform an immediate power-off, press and hold the power switch for
four seconds before releasing it.
Caution – The immediate power-off method does not perform an orderly shutdown
!
of the operating system and data might be lost.
3. Verify that the power-indicator LED on the power switch turns off after the
system completes its internal shutdown procedures.
4. Turn off power to the monitor and to all external devices.
en-24
The system shutdown menu is displayed.
The system performs internal shutdown procedures.
on page en-26):
FIGURE 6