Abicor Binzel ABIROB A Mode D'emploi page 40

11 Disassembly
11 Disassembly
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the gas supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
• Note the following instructions:
 8 Putting out of operation on page EN-16
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (change body, bracket, CAT robot mount, torch neck).
EN - 20
®
ABIROB
BAL.0125 • 2019-04-15
A