Haussmann 59595059 Guide De L'utilisateur page 22

FIG. 6
BEVEL
ADJUSTMENT
KNOB
FOOT
FIG. 7
TAB
Bevel adjustment
Disconnect battery pack from tool. The foot can be
adjusted up to 45 O by loosening the bevel adjustment
knob at the front of the saw. Align to desired angle on
calibrated quadrant. Then tighten bevel adjustment knob
(Fig. 8). Because of the increased amount of blade
engagement in the work and decreased stability of the
foot, blade binding may occur. Keep the saw steady and
foot firmly on the workpiece.
FIG. 8
Line guide
For a straight 90
For 45
BLADE
guide notch will give an approximate line of cut. Make
sample cuts in scrap lumber to verify actual line of cut.
This will be helpful because of the number of different
blade types and thicknesses available. To ensure
minimum splintering on the good side of the material to
be cut, face the good side down.
FIG. 9
General cuts
Always hold the saw handle with one hand and the auxiliary
handle or housing with the other.
Always ensure that the saw base plate rests on a portion
of the work surface that will not drop off.
22
QUADRANT
O cut, use left side of notch in the foot.
O bevel cuts, use the right side (Fig. 9). The cutting
90 O
VERTICAL
CUTS
BEVEL
ADJUSTMENT
KNOB
45 O
BEVEL
CUTS