Care And Maintenance - Bresser BIOLUX NV Mode D'emploi

3. In the event that you have connected more
than one unit, you can choose the desired
unit in the subsequent selection. Click on
"USB 2.0 Webcam". If only one device is
connected, this step is omitted.
4. The camera image should now be visible on
your screen. Focus the microscope image.
5. Click „Capture" to record an image. It will
then be shown on the right.
6. Click on it to select it and then click
„Transfer image".
7. This takes you to the Photomizer software.
8. File - Save as
12.3. The Photomizer Pro Software
(Bresser Edition)
If you need help in the „Photomizer" programme
click „?" and then „Open help". If you need
further assistance please visit the maker's
home page at www.photomizer.net/bresser

Care and maintenance

Separate the device from the power supply
before cleaning (remove batteries)!
Only use a dry cloth to clean the exterior of
the device.
24
nOTe:
Do not use any cleaning
fluid to avoid damaging the
electronics.
Clean the lenses (eyepiece and/or lens) with a
soft and lint-free cloth only (e.g. microfibre).
nOTe:
Do not apply excess pressure
to the cloth so as to avoid
scratching the lenses.
To remove more stubborn dirt, moisten the
cleaning cloth with an eyeglass-cleaning
solution and wipe the lenses gently.
Protect the device from dust and moisture.
Store it in the supplied bag or transportation
packaging. The batteries should be removed
from the unit if it has not been used for a long
time.
Troubleshooting
error solution
No picture visible switch light on
put condenser lens
in place
adjust focus
Picture flickers if necessary,
while viewing adjust resolution of the
with PC eyepiece video graphics board
Software installation confirm by
reports clicking "OK"
"not XP approved"
Specifications
system requirements for pC eyepiece
Minimum system requirements: PC with an
Intel Pentium IV processor or higher; Windows
XP with Service Pack 3*, Windows Vista
(32/64Bit) with Service Pack 2* or Windows
7 (32/64Bit) with Service Pack 1*; .NET
Framework 4.0*; min. 1024 MB RAM (64Bit
= 2048 MB); min. 500 MB free hard drive
space; free USB port; CD/DVD/BD drive.
*available for free via Windows Update
(Internet connection needed)