Slendertone Connect Abs 9 Mode D'emploi page 22

The
SLENDERTONE CONNECT ABS
specified below. The customer or the user of the
ensure that it is used in such an environment.
Immunity Test
Radiated RF
IEC 61000-4-3
NOTE 1 : At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 : These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/ cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the
measured field strength in the location in which the
exceeds the applicable RF compliance level above, the
should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary,
such as re-orientating or relocating the
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
22
Table 4 - Guidance and Manufacturer's Declaration - Electromagnetic Immunity -
for equipment and systems that are not life-supporting
9 containing a Bluetooth
IEC 60601 Compliance
Test Level Level
3 V/m
3 V/m
80 MHz to 2.5 GHz
SLENDERTONE CONNECT ABS
Radio Module is intended for use in the electromagnetic environment
®
9 containing a Bluetooth
SLENDERTONE CONNECT ABS
Electromagnetic Environment - Guidance
Portable and mobile RF communications equipment should be used
no closer to any part of the
Bluetooth Radio Module, including cables, than the recommended
®
separation distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
d = [1.17] ! P
d = [1.17] ! P...80MHz to 800 MHz
d = [2.33] ! P...800 MHz to 2.5GHz
Where P is the maximum output power rating of the transmitter in
Watts (W) according to the transmitter manufacturer and d is the
recommended separation distance in metres (m).
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey
in each frequency range
Interference may occur in the vicinity of equipment marked with the
following symbol:
SLENDERTONE CONNECT ABS
SLENDERTONE CONNECT ABS
9 containing Bluetooth
Radio Module should
®
SLENDERTONE CONNECT ABS
, should be less than the compliance level
a
.
b
9 containing Bluetooth Radio Module is used
®
9 containing Bluetooth Radio Module
®
Radio Module.
®
9 containing