Slendertone Connect Abs 9 Mode D'emploi page 10

Pairing Your Controller & Smart Device
Important:
You should Pair your controller with your smart device before it is inserted into the holster on the belt.
Ensure your controller is switched on, then open the app and complete the set-up proces. Follow the on-screen
instructions to pair your smart device with your controller.
Notes:
• Your controller and smart device should connect automatically every time they are both
switched on with Bluetooth
• If the pairing fails, your smart device will advise you of this and you should retry the
process.
Position the Conductive GelPads
1. Position the belt on a flat surface with the 3 metal studs facing upwards.
2. Remove the three adhesive GelPads from their pack. There is 1 large, square GelPad and
2 small, oval GelPads. One side of each GelPad has a grid pattern on it while the other
side is plain black.
3. Remove the covers from the patterned side of the square GelPad (Fig. b) and place
the GelPad patterned side down within the blue square to cover the central metal
stud (Fig. c). Press the edges of the GelPad firmly onto the belt.
4. Then remove the covers from the patterned side of the two oval GelPads and place
them patterned side down either side of the square GelPad (Fig. d) in the positions best
suited to your waist size (see page 8). Press the edges of both GelPads firmly onto the
belt.
Important :
• Make sure that all three silver studs are completely covered by the GelPads.
• You should only use
5. Align the contacts on the controller with those in the belt's holster, place the controller
on top of the holster and lightly push it down on both sides (Fig e) until the controller
clicks into place. Ensure the whole of the controller has been clicked into place.
10
enabled.
®
GelPads with your
SLENDERTONE SLENDERTONE CONNECT ABS
Fig. b
Fig. c
Fig. d
Fig. e
9 product.