Disc Playback; Playing Discs Or Files; Load The Disc; Play Tracks On A Cd - Pioneer X-HM36D Mode D'emploi

05

Disc playback

Chapter 5:
Disc playback
This system can play back a standard CD, CD-R/RW in the
CD format and CD-R/RW with MP3 files, but cannot record
on them. Some audio CD-R and CD-RW discs may not be
playable due to the state of the disc or the device that was
used for recording.
• For details about MP3, see page 33.

Playing discs or files

Load the disc

1 Press Í to turn the power on.
2 Press CD on the remote control or INPUT
repeatedly on the main unit to select CD input.
3 Press < on the main unit to open the disc tray.
4 Place the disc on the disc tray, label side up.
5 Press < on the main unit to close the disc
tray.

Play tracks on a CD

1 When the recognition is completed, press
1; .
After the last track is played, the unit will stop automatically.
14
En

Play MP3 music files

MP3 track data is called "music file" and the location they are
stored is called a "folder" in this document.
e.g.,
1 When the recognition is completed, press
/ to select the folder where the music file is
stored ([ ]), then press  or ENTER.
• Repeat this step if there are other folders inside the
selected folder.
• To return to the previous folder, press
Press / to select the music file ([ ]), and
2
then press 1; or ENTER.
• Once play starts, only music files inside the same folder
can be played continuously.
CAUTION
• Do not place two discs in one disc tray.
• Do not play discs of special shapes (heart, octagon,
etc). It may cause malfunctions.
• Do not push the disc tray whilst it is moving.
• If the power fails whilst the tray is open, wait until the
power is restored.
• Be sure to place 8 cm disc in the middle of the disc tray.
Note
• Due to the structure of the disc information, it takes
longer to read an MP3 disc than a normal CD
(approximately 20 to 90 seconds).
• When the beginning of the first track is reached during
fast reverse, the unit will enter the playback mode (only
for CD).
• If TV or radio interference occurs during CD operation,
move the unit away from the TV or radio.
Tip
• When no operation has done in CD mode and the audio
file is not played for more than 20 minutes, the power
will automatically turn off. In this case it is required that
the Auto power off is switched to ON.
• Auto power off can be switched to ON/OFF (page 36).

or .