Ugolini MT 1 MICRO Carnet D'instructions page 17

are turned back on in this situation, damage to
the mixers and their motor may result. Therefore,
mixers may be restarted only after product is
melted.
7
The dispenser is equipped with a magnetic
coupling by which the gear motor (located
outside the bowl) drives the mixers (inside the
bowl).
The magnetic drive operates as an "intelligent
clutch" able to automatically disconnect the
mixers in case they are seized by ice or other
causes.
This inconvenience can be soon noticed since an
intermittent dull noise warns that mixers are still.
In this case it is necessary to unplug immediately
the dispenser, empty the bowl and eliminate the
cause of seizing.
8
The dispenser must be able to emit heat.
In case it seems excessive, check that no
heating source is close to the unit and air flow
through the slotted panels is not obstructed by
wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
In any case if the product in the bowls is frozen
and the pressure switch warning light is OFF the
unit is running properly.
9
The product is for use with confectionery
only.
5. 3 CLEANING AND SANITIZING
PROCEDURES
1
Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation of
the best product taste and the highest unit
efficiency. This section is a procedural guideline
only and is subject to the requirements of the
local Health Authorities.
2
Prior to the disassembly and cleaning, the
machine must be emptied of product.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source by
unplugging it.
1
Remove cover from the bowl.
2
Remove the bowl by lifting its faucet side up
and off the fastening hooks (see figure 3) and
slide it out (see figure 4).
3
Slide the outer spiral out (see figure 5) and
then Outside magnetic rotor assembly (see
17
figure 3
figure 4