Revell Control VR QUAD VR SHOT Manuel De L'utilisateur page 24

Please note: Flips are more successful when the battery is still relatively full. Now
climb to the safety height. Press the button for the flip function (2J). The transmitter
beeps. Press the control for forwards/backwards and banking forwards. The model
executes a forward flip – flips in a different direction are executed according to the move-
ment of the controller. Then be ready to correct, as the altitude, direction and speed after
the flip depend largely on the wind and previous flight movements.
Landing:
Press the left controller for thrust and rotation and banking (7F), the model lowers to
the ground and the motors switch off.
You can also land manually. Then press the right control for forwards/backwards and
banking (7E), the motors switch off.
Emergency off button:
In case of an emergency, press the right control for forwards/backwards and banking
(7E), the motors switch off. Attention! Then the model falls to the ground!
12 TRIM ADJUSTMENT OF THE CONTROL
The correct trim is a basic requirement for fault-free flying behaviour of the model. Its
adjustment is simple, but it requires some patience and a feel for it. Please observe
the following instructions precisely: Carefully move the thrust control up and raise the
model approximately 0.5 to 1 metre in altitude.
12A If the model moves by itself slowly or quickly to the left or right ...
press the trim control for sideways (2I/8M) incrementally in the opposite direction.
12B If the model moves by itself slowly or quickly forwards or backwards ...
press the trim control for forwards/backwards (2H/8J) incrementally in the opposite
direction.
12C If the quadrocopter moves by itself slowly or quickly around its own axis
...
gradually press the trim for rotation (2D/8O) in the opposite direction.
13 HEADLESS MODE
When Headless Mode is activated, the model reacts to control commands, as though
the tail of the model always faced the pilot, regardless of the direction of the model.
Therefore, it can also be controlled ‚normally' without thinking.
Press the button for flight speed (40%, 70%, 100%) and Headless Mode (2B) for
longer than 3 seconds to switch Headless Mode on and off.
Attention: To function correctly, Headless Mode must be activated when
the tail of the model is pointing directly towards the pilot.
23