Inserting Batteries - Revell Control VR QUAD VR SHOT Manuel De L'utilisateur

3A Lock
4A Unscrew and remove
the cover.
5A Insert the feet in the bottom of the model and fasten them with the accompanying
screws.
5B Slide the camera into the front of the battery compartment cover until it clicks into
place.
5C Insert the cable in the corresponding jack. Pay attention to the correct polarity -
DO NOT USE FORCE.
Attention: The battery and motor must cool down for 10 to 15 minutes before charging
and after every flight. Otherwise they can be damaged. The charging process must
be constantly monitored. Always ensure that the charging process takes place on a
fireproof surface in a fire-resistant environment.
1. Slide the camera forwards to detach it (6A).
2. Unscrew the securing screw of the battery compartment cover and slide it back to
open it (6B).
3. Remove the battery from the model (do not pull on the cable).
4. Plug the battery into the charging socket of the charger, ensuring correct polarity.
The battery must be gently inserted into the charging socket – DO NOT USE FORCE.
If the battery is not correctly inserted into the charging socket, the battery may
become damaged and, under certain circumstances, cause injury.
5. Insert the USB charger in a free USB port; it will illuminate (6C).
6. The charging process is complete when the USB charger light goes out.
7. Disconnect the battery from the USB charger and disconnect the USB charger from
the USB port once charging is complete.
After a charge time of approx. 75 minutes the model can fly for approx.
5-7 minutes.
Warning notice: The battery does not normally heat up while charging. If it should
become warm or even hot and/or changes to the surface begin to appear, immediately
discontinue the charging process!
3 VR GOGGLES
3B Belt

4 INSERTING BATTERIES

4B Insert 4 x 1.5 V AA
batteries and pay
attention to the polarity,
as shown in the battery
compartment.
5 ASSEMBLY
4 CHARGING THE MODEL
3C Rotary knob
4C Close the battery cover
and secure with the
screw.
19