Xylem PolluStat Instructions De Montage Et Manuel D'utilisation page 93

Use a screwdriver with a wide tip (4 - 5 mm) and carefully press in the two round predetermined breaking points above the
cable feedthroughs (see picture 1).
Then insert the screwdriver into one of the two openings at an angle of approx. 45° and carefully lift the handle up to approx.
90° (see picture 2). The upper housing piece of the calculator is then no longer latched on this side. Repeat this with the other
opening. Now the upper housing piece can be taken off.
Plug the interface module on the right side of the PC board. The cables are to be fed through the rightmost cable feedthroughs
into the calculator after removing the blind grommets. Close the calculator.
Protect the calculator against unauthorized opening using one of the numbered adhesive seals enclosed to the modules (stick it
upon the seal destroyed). The added bar code label can be used for the purpose of documentation.
Page 93 of 108 Article no.: 1080619046 2020_07_27 Subject to technical change! Errors excepted.