16
4.6
GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
EN
edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZER
from your authorized dealer / distributor.
4.7
LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing
door, as indicated.
W415-1344 / A / 12.14.16
TM
logs available
TM
½"
(12.7mm)
LOGO
½"
(12.7mm)
97.1A