Correcting The Distortion - Maxell MP-WU9101B Manuel D'utilisation

Installation of the Projector
Note for adjusting the lens shift
1. Adjust the lens shift / zoom / focus 30 minutes after turning on the projector.
2. Slight changes in the image position and/or focus may occur within 30 minutes after turning on the
projector. If the room temperature and humidity have changed after adjusting the lens shift / zoom / focus,
readjust as necessary.
3. In anticipation of the changes after installation, set up the image size including the margin from the screen edge.
4. When adjusting the lens shift vertically, finish adjusting lens shift by moving the projected screen upward.
If you finish adjusting the lens shift by moving the projected screen downward, the projected screen may
be misaligned slightly downward over time.

8. Correcting the distortion

Press MENU on the remote control or Keypad. You can use
OSD to correct the distortion of a projected screen.
• EASY MENU → KEYSTONE or PERFECT FIT
• ADVANCED MENU → SETUP →
GEOMETRY CORRECTION → KEYSTONE or
PERFECT FIT
KEYSTONE
Adjusts the vertical and horizontal keystone.
Note: When the horizontal lens shift is not set to the center, this function may not work correctly.
PERFECT FIT
Adjusts each of the screen corner and side to correct the distortion. For details, see User's Manual -
Operating Guide.
WARPING
Projects an image on several types of screen.
Note: Press EXIT to exit, or wait several seconds until the OSD menu automatically disappears.
Note: When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function
should be used when the zoom adjustment is set to the full WIDE (wide-angle focus).
• When the horizontal lens shift is not set to the center, this function may not work correctly.
• Select RETURN in the dialog with the ▲/▼ buttons and press the ◄ or ENTER button to return to the
GEOMETRY CORRECTION menu.
22 22
English- English-
KEYSTONE or PERFECT FIT on