Starting Up The Projector; Adjusting The Projector's Angle, Lens Shift, Zoom, Lens Centering, And Focus - Maxell MP-WU9101B Manuel D'utilisation

6. Starting up the projector

Make sure that the POWER indicator is lighting in steady red. Press the
the ON button on the remote control. The projector will be turned on and the POWER indicator will
begin blinking in green. When the power is completely on, the POWER indicator will stop blinking
and the light will become steady green. The LIGHT indicator will also become steady green.

7. Adjusting the projector's angle, Lens Shift, Zoom, Lens Centering, and Focus

a. Use the adjustable feet to change the angle of the projector in order to achieve the most suitable
angle for projection on the screen.
b. Adjust the lens by horizontal and vertical lens shift, and adjust Zoom and Focus of lens.
Method 1: Using the Keypad on the projector.
Method 2: Using the button on the remote control.
Press the SHIFT button on the remote control to access Lens
Shift. Use the
vertical position of the lens. Press FOCUS, ZOOM button
then use the
The Lens shift, Zoom or Focus dialog will appear when you press the buttons of SHIFT, ZOOM or
FOCUS. Generally, better image can be got when the lens is set to the center.
Note : While the lens is moving to the center, the OSD will disappear and an hourglass icon will
appear on the screen. CENTERING may take some time till the lens reaches to the center.
* Perform CENTERING before the projector is turned off.
* The adjustable range of LENS SHIFT varies depending on which lens is mounted on the projector.
Therefore, LENS SHIFT adjustment may not reach the end of the indicator in the dialog. This is not a
malfunction.
(continued on next page)
▲ ▼◄►
buttons to adjust the horizontal or
◄►
buttons to adjust the focus and zoom.
Installation of the Projector
button on the projector or
LENS
FOCUS ZOOM
SHIFT
SHIFT
21 21
English- English-