Cleaning The Venturi - Coleman 9962 Serie Manuel D'assemblage, D'entretien Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

COOKING GRATE
The cooking grates can be cleaned immediately after
cooking is completed and after turning off the grill. Wear a
barbecue mitt and scrub the cooking grates with a damp
cloth. If the grill is allowed to cool down, cleaning the grates
will be easier if removed from the grill and cleaned with a
mild detergent.
All cleaning and maintenance should be done only
when the grill is cool & with the fuel supply turned off
at the cylinder. Disposable propane cylinders should be
detached from the grill during cleaning.
Suggested Cleaning Materials:
• Mild dishwashing liquid detergent • Hot water
• Wire brush • Paper clip • Nylon cleaning pad
• Soft brass-bristled brush • Putty knife • Scraper
Component Cleaning:
• BURNER: Wire-brush loose corrosion from the burner
exterior. Clean clogged gas port holes with an opened
paper clip. Replace corroded or damaged burner that
would emit excess gas.
• COOKING GRATE: Clean cooking grates with mild soap
and hot water. Remove stubborn residue with a mild
cleanser or scrub brush. DO NOT use a commercial oven
cleaner.
• GRILL INTERIOR: Remove grates. Scrape side with tools
and remove excess grease and cooking residue.

Cleaning the Venturi

WARNING
Spider's nests or wasp's mud inside the venturi may
cause fire at the valve. If a fire occurs, immediately turn
off the gas supply at the control valve (see representative
illustration in Fig. 26).
CAUTION
Fig. 25
Note:
Spiders and small insects can spin webs and build nests
inside the venturi tubes. This especially occurs in late
summer and fall before frost when spiders are most active.
These nests can obstruct gas flow and cause a fire in and
around the burner knob. Such a fire can cause operator
injury and serious damage to the grill. To help prevent a
blockage and ensure full heat output, clean and inspect the
venturi tubes often (once or twice a month). NOTE: Water or
air pressure will not normally clear a spider web.
Steps For Cleaning Venturi:
1. To remove the above obstructions, use an accessory
flexible venturi brush or bend a small hook on one end
of a 20-inch long flexible wire such as the one shown in
Fig. 27.
2. Remove the cooking grates set aside.
3. Using a screwdriver, remove the self-tapping screws
holding the burner clamps beneath the case and
remove the burner. (Fig. 28)
4. Look inside lower end of venturi tube for nests, webs or
mud. If present, clean as noted in Step 1, Fig. 27.
5. Inspect and clean the burner if needed.
6. Replace the burner and burner clamps, and position the
burner in the operating position.
English - 11
REPRESENTATIVE ILLUSTRATION
Fig. 26
Fig. 27
Fig. 28

Publicité

Table des Matières
loading

Table des Matières