Work Area - Hilti SF 2-A Mode D'emploi

5.3.3 Battery tool use and care
a) Ensure the switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites
accidents.
b) Do not expose batteries to high temperatures and keep them away
en
from fire. This presents a risk of explosion.
c) Do not disassemble, squash or incinerate batteries and do not
subject them to temperatures over 80°C. This presents a risk of fire,
explosion or injury through contact with caustic substances.
d) Avoid ingress of moisture. Ingress of moisture may cause a short
circuit, resulting in burning injuries or fire.
e) Use only batteries of the type approved for use with the applicable
power tool. Use of unapproved batteries or use of the batteries in areas
of application for which they are not approved presents a risk of fire and
explosion.
Observe the special guidelines applicable to the transport, storage
f)
and use of Li-ion batteries.
g) Remove the battery before storing or transporting the tool.
h) Avoid short circuiting the battery terminals. Before inserting the
battery in the tool, make sure that the battery terminals and the
terminals in the tool are free from foreign objects. Short circuiting the
battery terminals presents a risk of fire, explosion and chemical burns.
i) Do not charge or continue to use damaged batteries (e.g. batteries
with cracks, broken parts, bent or pushed-in and/or pulled-out
contacts).
j) If the battery is too hot to touch it may be defective. Place the tool in
a location where it can be kept under observation, well away from
flammable materials, and allow it to cool down. Contact Hilti Service
after the battery has cooled down.
5.3.4 Electrical safety
Before beginning work, check the working area (e.g. using a metal
detector) to ensure that no concealed electric cables or gas and water
pipes are present. External metal parts of the power tool may become live,
for example, when an electric cable is damaged accidentally. This presents
a serious risk of electric shock.

5.3.5 Work area

a) Ensure that the workplace is well lit.
b) Ensure that the workplace is well ventilated. Exposure to dust at a
poorly ventilated workplace may result in damage to the health.
12
Printed: 30.05.2017 | Doc-Nr: PUB / 5174912 / 000 / 02 Printed: 30.05.2017 | Doc-Nr: PUB / 5174912 / 000 / 01