Sonnenkonig CUBY Mode D'emploi page 32

2 Operation
Plug the heater into the socket. Make sure there are no flammable materials within a
two-metre radius.
GB
0 OFF
Fan only, no heat
I Low heat output (750 Watt)
II Full heat output (1500 Watt)
Thermostat:
The thermostat will only work on the stages I and II. Turn the thermostat clockwise to
increase the heating power.
To use the fan function
• Turn the control dial to «FAN». The fan will blow air out at room temperature.
• If the fan does not operate, the ambient room temperature is cooler than the «OFF»
level of the built-in thermostat. gradually turn the thermostat dial clockwise and the
fan will start blowing.
• As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating
• Turn the control dial to «I» for low heat or «II» for full heat.
• Set the heat level by gradually turning the thermostat dial clockwise for the lowest heat
and fully clockwise for maximum heat.
• The thermostat will turn the machine off when the set room temperature is reached.
When the temperature drops, it will turn on again automatically.
• For maximum heat output use «II» with the thermosat turned fully clockwise.
Overheating
• The thermostat will turn the machine off in case it overheats.
• Overheating can be caused by blocked air intakes on the back of the machine or a blo-
cked grill on the front. If this occurs, please disconnect the machine and allow it to cool
for 30 minutes. Clear the blockage and turn the machine back on.
• If the heater ceases to function, the most likely cause is a blown fuse. Simply replace
the 13amp fuse in the plug and reconnect. If there is still no function please follow the
repair advice above.
:
32