dB Technologies VIO-L208 Caractéristiques Techniques page 55

• Bring the additional 4 modules with a second DT-VIOL208 dolly under the first 4, currently suspended.
• Remove the safety strap and adjust the angles as described in the previous step.
• Properly lower the 4 suspended modules and hook them as described in the
for both front and rear. Pay careful attention to this step when moving the upper suspended block (the
engine ropes must always be kept taut). In the 2 coupling phases, front and rear of the 2 units, in the
case of 2 engines, it is possible to push the 2 modules concerned slightly forward to make coupling
easier. Always use only the module handles for holding it.
• Complete audio, RDNet and power supply re-link connections as described in the previous paragraphs.
To find the maximum number of power connections in a re-linked system, see the
SPECIFICATIONS
necessary, check with a laser inclinometer (not provided) that the inclination of the fly-bar corresponds
to the one in the project. Check that all the pins have been fully inserted and are locked.
• Remove the brakes from the DT-VIOL208 dolly and remove it.
• Lift the assembled line array with maximum care.
• Implement any other fastening technique necessary for the safe and stable use of the line array, also
considering any atmospheric phenomena it may be exposed to.
VIO-L208
54
section. Slightly lift the line array to verify the correctness of hooks and angles. If
English
MECHANICS paragraph
TECHNICAL
Cod. 420120268 REV. 1.0