dB Technologies VIO-L208 Caractéristiques Techniques page 38

English
The assembly of the 2 modules A and B requires a few easy steps:
• On module A remove the pins [3], raise the retractable brackets [2] and fasten them to the new position
using the pins [3].
• Remove the pins [1] from module B, place it on top of module A, inserting the brackets [2] as shown. Then
fasten the front side of the two modules using the pins [1] of module B.
• At the back, remove the pins [5] from the rear brackets [4]. Then insert the movable arm [6] of module B
into the bracket [4] of module A. The next page shows the details of the corner fixing on the back between
the two modules.
VIO-L208 Cod. 420120268 REV. 1.0
37