Input, Output And Control Section - dB Technologies VIO-L208 Caractéristiques Techniques

English

INPUT, OUTPUT AND CONTROL SECTION

1. INPUT AND OUTPUT LINK ("Balanced audio")
Input and output compatible with balanced XLR cables.
In particular, "Input" is used to connect with the audio signal coming from the mixer or from another loudspeaker,
"Output Link" is used to link the signal to the other modules of the line-array, in daisy-chain configuration.
2. AUDIO ATTENUATION
Allows adjusting the attenuation of the module using the input volume.
Before installing the line array, set at 0 dB.
3. INPUT AND NETWORK CONNECTION LINK RDNet
Section compatible with network cables with etherCON/RJ45 connectors.
In particular, "Data in" must be connected to devices such as RDNet Control 2 or Control 8; "Data Out" is used to
link the network to additional modules of the line array in daisy-chain configuration.
4. DSP PRESET
Rotary for the acoustic setup of the line array.
It is advisable to use these controls (or the same parameters remotely via RDNet connection) to optimize the
acoustic behavior as a function of the number of modules and their aiming. An in-depth analysis on the use of
"SPEAKER COUPLING" and "HIGH FREQUENCY COMPENSATION" can be found in the
AND REMOTE CONTROL" section.
5. STATUS LEDs
LEDs relating to module operation. A table in next page summarizes the meaning of the different LEDs.
6. CONTROL LEDs
LEDs relating to module network operation (RDNet).
In particular, if "Link" is on the RDNet network is active and has acknowledged the device, if "Active" is flashing
there is data traffic, if "Remote Preset Active" is on all local control on the amplifier panel are by-passed by the
RDNet remote control.
7. SERVICE DATA USB PORT
It is a mini-USB B port to be used only for product firmware update. For further information refer to "FIRMWARE
UPDATE".
VIO-L208
"DSP PRESET PARAMETERS
Cod. 420120268 REV. 1.0
41