Wrap The Pipes And Cables - CLIVET CRISTALLO IM1-XY Serie Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien

Installation
Connections in SINGLESplit configuration
INDOOR unit terminal block
Morsettiera unità INTERNA
W 1(L) 2(N)
signal
segnale
to the terminal block of
alla morsettiera
the OUTDOOR unit
dell'unità ESTERNA
Connections in MULTISplit configuration
Morsettiera unità INTERNA
Morsettiera unità INTERNA
W 1(L) 2(N)
power supply
alimentazione
to the terminal block of
alla morsettiera
the OUTDOOR unit
dell'unità ESTERNA
S
power supply
alimentazione
Fig. 14
S
signal
segnale
Fig. 15
2.4.7

Wrap the pipes and cables

It is necessary to wrap the coolant pipes, drainage pipe
and electrical cables together; this reduces the space
occupied, protects them and insulates them before
passing them through the hole in the wall.
1 Assemble the drainage pipe, coolant pipes and cables
as indicated in "Fig. 16".
Indoor unit
Electric Drainage
cables pipe
m
CAUTION
– Make sure that the drainage pipe is on the
lower part of the unit. Placement of the
drainage pipe at the top of the unit may
cause the drain pan to overflow, which may
result in fire or water damage.
– When winding the pipes and cables, leave
the ends of the pipes free. These should be
accessible to check for leaks after installation
is complete (see section "3.2 Electrical
dispersion and gas leakage control" of the
outdoor unit manual).
– When assembling cables, avoid twisting or
tangling the signal cable with other types
of cable.
2 Using vinyl adhesive tape, fasten the drain pipe to the
bottom side of the coolant pipes.
3 Using insulating tape, wrap the electrical cables,
coolant pipes and drainage pipe together. Check that
all components are joined together as indicated in
"Fig. 16"
Space behind
the unit
Refrigerant
piping
Insulating
tape
Fig. 16
19