Drainage Pipe - CLIVET CRISTALLO IM1-XY Serie Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien

Installation

2.4.5 Drainage pipe

In the default configuration, the drainage pipe is connected
to the left side of the unit (looking at the back of the unit).
However, it can also be connected to the right side.
1 To ensure proper drainage, secure the drainage pipe
on the same side as the refrigerant piping.
2 Attach the drainage pipe extension (to be purchased
separately) to the end of the pipe.
3 Tightly wrap the connection joint with Teflon tape to
ensure a good seal and prevent possible leakage.
4 The part of the drainage pipe that remains inside
should be wrapped in a foam sleeve to prevent
condensation from forming.
5 Remove the air filter and pour a small amount of water
into the drain pan to make sure the water is draining
properly from the unit.
l
WARNING
To prevent unwanted leakage, the unused
drain hole must be closed using the rubber
cap provided.
upward bends or bottlenecks.
CORRECT
Check the drainage pipe for
Fig. 11
d
IT IS PROHIBITED TO
– bend the drainage pipe upwards;
– create stagnation points;
– submerge the end of the drainage pipe in
water or in a water collection container.
NOT CORRECT
An upward bend in
the drainage pipe
can create water
stagnation points.
NOT CORRECT
Do not submerge the
end of the draining pipe
in water or in a water
collection container. This
would prevent a proper
outflow.
NOT CORRECT
An upward bend in
the drainage pipe can
create water stagnation
points.
Fig. 12
17