CLIVET CRISTALLO IM1-XY Serie Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien page 50

Hole in the wall
on the left rear
side, 65 mm
53.5 mm
Hole in the wall
on the left rear
side, 90 mm
FIX THE MOUNTING PLATE TO THE WALL
1 Remove the screw that fastens the mounting plate to
the back of the indoor unit.
2 Place the mounting plate on the wall in a position
that meets the requirements listed in paragraph
"2.4.1 Installation room" (for detailed information on
the dimensions of the mounting plate see ""Mounting
plate dimensions".)
3 Drill the holes for the fixing screws in positions that:
– are strong enough and have sufficient capacity to
support the weight of the unit
– match the holes in the mounting plate
4 Fix the mounting plate to the wall using the screws
provided.
14
35M Model
138 mm
34 mm
965 mm
53M Model
219 mm
76 mm
174.3 mm
1080 mm
70M Model
517.4 mm
144 mm
553 mm
300 mm
148.7 mm
47 mm
Hole in the wall on the right
151 mm rear side, 90 mm
5 Check that the mounting plate is in line against
the wall.
l
WARNING
If the wall is made of brick, concrete or similar
materials, drill holes with a diameter of 5 mm
and insert the anchors provided. Then fix the
mounting plate to the wall by tightening the
screws directly into the anchors.
If the wall is made of other materials, use
suitable fasteners and check that they are
properly sealed.
Installation
Indoor unit
profile
Hole in the wall on
the right rear side,
65 mm
53.5 mm
Indoor unit
profile
Fig. 6