Connecting Sensors; Connecting Autosampler; Connecting Stirrers; Connecting Pnp Devices - Mettler Toledo SevenExcellence Serie Guide De L'utilisateur

Note
In the standby mode, the control circuit for the On/Off switch is energized. The rest of the instrument is no
longer energized.

4.6 Connecting sensors

Connect the sensor and make sure that the plugs are properly inserted. For sensors with a built-in temperature
probe, connect the second cable to the appropriate ATC socket (ATC int). When using seperate temperature
sensors, connect the cable to the appropriate ATC socket (ATC ext).Twist the RCA (Cinch) plug to ease the
attachment of the sensor.
®
ISM sensor
®
ISM sensors are automatically recognized upon connection.
When connecting an ISM
running, the sensor identification will be displayed after the endpoint of the analysis is reached.

4.7 Connecting autosampler

InMotion autosampler
With the InMotion autosampler the automatic measurement of up to 303 samples is possible. InMotion is only
supported when the instrument is connected to the LabX software. The InMotion autosampler is connected to
the instrument with an USB cable and can only be used in LabX connected mode. Several different configu-
rations are available for the InMotion autosampler depending on your requirements.
Rondolino sample changer
With the Rondolino sample changer the automatic measurement of up to 9 samples is possible. To connect the
Rondolio sample changer to the instument, a "Rondolino USB-TTL box" is required. Use the USB cable to
connect the USB A interface of the instrument to the USB-TTL box. Use the 9-pin cable to connect the the
Rondolino sample changer with the TTL box. Connect the compact stirrer to the stirrer adapter cable and then to
the instrument. The compact stirrer is an overhead stirrer.

4.8 Connecting stirrers

Connect uMix™, the METTLER TOLEDO external magnetic stirrer, or the METTLER TOLEDO Compact Stirrer
(overhead stirrer, adapter cable needed) to the instrument. The stirrers are powered by the instrument and will
be automatically switched on/off during an analysis according to the settings. Before connecting a stirrer,
switch off the instrument. Use the stirrer socket (Stir) on the rear side, note the designation. Note the corre-
sponding chapter of the operating instructions concerning the settings of peripheral devices.

4.9 Connecting PnP devices

USB sticks, barcode reader, US-P25 printer and fingerprint reader can be connected to the instrument via the
USB connections on the left side of the instrument for immediate use. The instrument has a plug & play
detection to support the comfortable handling of peripheral devices.

4.10 Connecting computers

The instrument can be connected to a PC with LabX or EasyDirect pH software.
Connected to the PC software LabX via USB or Ethernet, SevenExcellence profits from additional functionalities
such as data and resource management, report creation and ERP/LIMS integration. The instrument can be
controlled via touchscreen and PC software. In addition, LabX offers regulation support (e.g. 21 CFR part 11)
and allows combined analysis with other METTLER TOLEDO laboratory instruments.
Find out more and visit us on:
The PC software EasyDirect pH allows for easy and efficient transfer of results to a PC. SevenExcellence is
connected via USB, one instrument per PC.
For simplified data transmission to a PC or network via RS232, the RS232 Compact Printer can be selected in
the printer settings.
20 Putting into Operation​ ​
®
sensor to the instrument, verify that no analysis is running. In case an analysis is
www.mt.com/LabX
SevenExcellence™