Roborock S7 Manuel D'utilisation page 18

Installation
Power on and charge the robot
3
Press and hold the button to power on the robot. When
the power light goes on, place it on the dock to charge. To
maintain the performance of the high-performance lithium-ion
rechargeable battery pack, keep the robot charged.
Note: The robot may not turn on when the battery is low. In this case, place the robot
directly onto the dock to charge.
The power indicator color
indicates the battery level:
• White: Battery level ≥ 20%
• Red: Battery level < 20%
Mopping the floor
4
Note: To prevent excessive buildup of dirt on the mop, floors should be vacuumed at
least three times before the first mopping cycle.
1. Remove the water tank
Release the water tank latch and slide the tank backward.
2. Fill the water tank
Open the water tank, fill it with water, and close it tightly.
Note:
• Fill with water only. Cleaning fluids and/or disinfectants may corrode the water tank.
• Use cold/room temperature water only. Hot water may cause water tank deformation.
018