Troubleshooting - I-Tech MIO-PERISTIM Notice D'utilisation

and carefully stored on a secure surface. The performances of the equipment
are granted if it is stored according to the following conditions:
Outside the carrying bag:
Temperature
Relative humidity
Pressure
Inside the supplied carrying bag:
Temperature
Relative humidity
Pressure
N.B. Disconnect the cables, before storing the device into its carrying bag. If
not, the cables could bend excessively near the connectors. It could severely
damage the cables.

Troubleshooting

Any type of work on MIO-PERISTIM must be carried out exclusively by the
manufacturer or by an authorized dealer. In any event, any presumed
malfunction of MIO-PERISTIM must be verified before sending the device to
the manufacturer.
Here below are some typical situations:
MIO-PERISTIM cannot be turned on and/or the display does not light
•
up:
Check the battery status and replace it if it is necessary (make
-
reference to chapter Battery replacement).
If the problem persists contact the manufacturer
MIO-PERISTIM does not transmit electric impulses:
•
Check that the cable jacks have been inserted in the electrodes and
−
that the plastic protection has been removed from the electrode.
Check that the cables have been connected correctly (connector
−
well inserted in the device).
Check that the cables and the electrodes are not damaged.
−
If the problem persists contact the manufacturer.
MIO-PERISTIM transmits low intensity or intermittent impulses:
•
Check the cables and the electrodes are in good condition and
−
replace them if it is necessary.
If the problem persists contact the manufacturer.
MIO-PERISTIM switches off during the operation:
•
− It is suggested to replace the battery and start a new treatment.
If the problem persists contact the manufacturer.
IACER Srl
from 5 to +40°C
from 30 to 75%
from 700 to 1060 hPa
from -10 to +55°C
from 10 to 90%
from 700 to 1060 hPa
69 MNPG152-07