I. FITTING THE KOOS iSIZE ONTO YOUR JANÉ
PUSHCHAIR
Your KOOS iSIZE can be fastened onto any JANÉ chassis fitted with the
Pro-fix connectors (always check the pushchair instructions before
fitting the KOOS iSIZE).
To fasten the safety seat onto a chassis, insert the Pro-fix connectors
into the slots in the chassis and press.
correctly when you hear it lock into place and a green strip is dis-
played on the Pro-fix lever (found on the handle joint).
To release the KOOS iSIZE from the chassis, simultaneously pull the re-
lease levers upwards found on both sides of the chassis joints and lift
the baby carrier up.
.c
5
!
WARNING: The KOOS iSIZE should always be attached to the
pushchair so the baby is facing the parent.
.a
Your KOOS iSIZE is fastened
5
.b
5
J. HOOD
The hood of your KOOS iSIZE is detachable. Simply unfasten the elastic
cords on the sides of the upholstery and pull the sides of the hood arch
until it is free. To fit the hood again, follow the same steps in reverse.
!
WARNING: The hood arch only has one possible assembly
position. Make sure that the grey marks on the arch and handle
are aligned as shown in the diagram.
6
.
EN
49