Koos Isize Installation With The Vehicle Seat Belt; Fasten The Baby Into The Safety Seat - JANE Koos iSize Mode D'emploi

G. KOOS iSIZE INST ALLA TION WITH THE VEHICLE SEA T BEL T
The KOOS iSIZE safety seat must be installed FACING THE OPPOSITE
DIRECTION IN WHICH THE CAR IS TRAVELLING. Decide on the seat after
reading the "Choosing where to install the safety seat" section.
To install the seat carefully follow the steps below:
3 .a Position the safety seat on the vehicle seat.
3 .b Pass the seat belt buckle over the baby's feet and fasten it.
3
.c Insert the abdominal part of the seat belt through the slots (1) on
the sides of the frame.
3 .d The shoulder part of the vehicle seat belt should be passed be-
hind the safety seat.
3 .e Turn the handle (6) to the AUTO position, the furthest forward. The
car symbol on the sides of the handle should be visible.
3 .f Tighten the car seat belt and fasten the locking clip (2). Make sure
that the safety seat is securely anchored by pulling it.
WARNING: For installing rear facing safety seats, the correct gui-
!
des for fitting the seat belt are marked on the chassis in blue.
DO NOT use any guide that is not described in these instructions
or any on the baby carrier that are not coloured blue.
If the safety seat is installed with the ISOfix base (optional), follow the
instructions on the base.
48
EN
H. FASTEN THE BABY INTO THE SAFETY SEAT
Loosen the harness system by pressing the central adjustment button
while carefully pulling the belt fastener.
4
Unfasten the belt .b and hold the shoulder straps between headrest
and shoulder area. 4 .c
Place the child in the KOOS iSIZE. Pass the straps over the child's shoulders
and bring them together in front of the child's body, then fasten the belt.
4 .d
In order to provide maximum protection, the shoulder straps of the
KOOS iSIZE safety seat should be adjusted so they go just above the
baby's shoulders. Check the height of the straps when the baby is
correctly positioned in the seat. 4
Your KOOS iSIZE safety seat is fitted with a shoulder strap quick height
adjustment system by using the headrest position adjustment button.
Pull the handle on the headrest and slide it along the backrest to
the required position. Check that it is locked into place by pulling the
adjustment mechanism. 4 .f
Tighten the harness system by pulling the central belt so that it fits the
child's body snugly, you should be able to insert just two adult fingers
between the straps and the occupant.
! WARNING: Check and adjust the height and length of the shoul-
der straps as the baby grows.
4 .a
.e
4
.g