Reclining The Seat; Attaching The Nest Baby Carrier To Your Jané Pushchair - JANE CONCORD GROOWY iSIZE Mode D'emploi

Adjusting the height of the headrest
• The height of the headrest is adjusted using the handle found on the
top part of the headrest at the back. To release the lock pull the button
upwards, when you release the button the headrest will lock into the nea-
3
rest position. .k
• Pass the lower lap part or the shoulder part of the vehicle seat belt through
the belt guide at the side of the headrest (11).
• Position the child in the booster seat, and adjust the height of the headrest
using the button (4). The seat belt should be slightly above the child's
3
shoulder. .m
!
IMPORTANT: Adjust this height as the child grows
Placing the child in the seat
• Position the child in the booster seat and pass the vehicle shoulder seat belt
through guide at the side of the headrest (11).
• Pass the seat belt over the child and fasten the buckle
• Lastly, pass the belts under both armrests (10).
When you get the child out of the booster seat it is not necessary to take the
seat belt out of the guide at the side of the headrest (11), this makes it easier
to fasten the child in the next time the booster seat is used.
IMPORTANT: Even when the booster seat is not in use it should be se-
!
cured with the seat belt; in the event of an accident or sudden braking
it could get flung about and injure the other occupants of the vehicle.
Removing the seat:
• Release the ISOFIX anchors by pulling both the release straps (7). The
• Remove the seat. Press the ISOFIX anchors (6) to store them inside the
N_RECLINING THE SEAT
3 .l
The GROOWY seat is reclined using a lever found on the sides of the
seat (12). It has 5 positions. This action, when the seat is used as a
booster seat with backrest, requires the vehicle 3-point seat belt to
be adjusted, in this case it should be carried out while the vehicle is
stationary.
• To recline the seat, turn the lever forwards and slide the seat to the requi-
O_ATTACHING THE NEST BABY CARRIER TO
3 .l
• Your NEST can be attached to any JANÉ pushchair fitted with Pro-fix
• To fit the baby carrier onto a chassis, insert it into the Pro-fix slots on
• To release the NEST from the chassis, simultaneously pull the release
signals on the front (8) will turn red.
base.
red position.
YOUR JANÉ PUSHCHAIR
connectors (always check the pushchair instructions before attaching the
baby carrier).
the chassis and press. 4 .a Your NEST will be securely attached when
you hear it click into place and a green band appears in the top part of
the Pro-fix handles (found above the pivot section of the handle).
4
.b
31
EN